Overview - Bumper Cover, Except AUDI RS5
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Trim Strip
- Audi S5 only
- Removing and installing. Refer to Installing => Trim Strip .
- Bolt
- 1.5 Nm
- Quantity: 9
- Bumper Cover Lower Section
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING, EXCEPT AUDI RS5 => Lower Section .
- Bolt
- 1.5 Nm
- Quantity: 2
- Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
- Left Rear Parking Aid Sensor -G203-
- Removing and Installing. Refer to Parking Aid .
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Fig 2
- Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING => Side Mount .
- Clip nut
- Quantity: 3
- Bumper Cover Locking Mechanism
- Clamping screw tightening specification 2.5 Nm.
- Removing and installing. Refer to Installing => Retainer .
- Clip nut
- Quantity: 2
- Bolt
- Quantity: 2
- Tightening sequence. Refer to Fig 2
- Nut
- 4 Nm
- Left Rear Center Parking Aid Sensor -G204-
- Removing and Installing. Refer to Parking Aid .
- Right Rear Center Parking Aid Sensor -G205-
- Removing and Installing. Refer to Parking Aid .
- Nut
- 4 Nm
- Right Rear Parking Aid Sensor -G206-
- Removing and installing. Refer to Parking Aid .
- Cap
- For the towing eye
- Bolt
- 1.5 Nm
- Quantity: 3
Side Mount and Bumper Cover Locking Mechanism - Tightening Specifications and Sequence
-- Tighten the bolts to 1.5 Nm in the following sequence: -1 to 5- .