Overview - Bumper Cover, AUDI RS5
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 2 Nm
- Quantity: 5
- Rear Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .
- Trim for Left Tail Pipe
- Removing and installing. Refer to Installing => Tail Pipe Trim .
- Bolt
- 2 Nm
- Quantity: 4
- Left Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING .
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Fig 2
- Bumper Cover Locking Mechanism
- Adjusting bolt tightening specification: 3 Nm
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- Tightening sequence. Refer to Fig 2
- Center Guide
- For the bumper cover
- Removing and installing. Refer to Installing => Center Guide .
- Nut
- 1.5 Nm
- Quantity: 2
- Rear Parking Aid Sensor
- Removing and installing. Refer to Parking Aid .
- Trim for the Right Tail Pipe
- Removing and installing. Refer to Installing => Tail Pipe Trim .
- Bumper Cover Locking Mechanism
- Adjusting bolt tightening specification: 3 Nm
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING .
- Bolt
- Quantity: 2
- Tightening sequence. Refer to Fig 2
- Right Side Mount
- For the bumper cover
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING .
- Bolt
- Quantity: 3
- Tightening sequence. Refer to Fig 2
- Bolt
- 2 Nm
- Quantity: 4
- Cap
- For the towing eye
- Diffuser Trim
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS5 => Diffuser Trim .
Side Mount and Bumper Cover Locking Mechanism - Tightening Specifications and Sequence
-- Tighten the bolts to 2 Nm in the following sequence: -1 to 5- .