Impact Absorber, Removing And Installing, Vehicles With Trailer Hitch: Removing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING, EXCEPT AUDI RS5 .
-- Remove the trailer hitch socket.
-- Free up the spiral clip -1- for the wire.
NOTE:
Use a soapy solution if necessary make removal easier.
-- Disconnect the electrical connector on the Radio Frequency Controlled Clock Receiver -J489- -2- , if equipped.
NOTE:
If the impact member -3- is replaced, the Radio Frequency Controlled Clock Receiver -J489- must be removed. Refer to Clock .
-- Remove the tie downs. Refer to Luggage Compartment Trim Panels .
-- Loosen the left and right luggage compartment side trim panel. Refer to Luggage Compartment Trim Panels .
-- Remove the bolts -arrows- and the impact bar -3- .