Overview - Bumper Cover, AUDI RS5
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 2 Nm
- Quantity: 3
- Spoiler Lower Section
- Removing and installing. Refer to Installing => Spoiler Lower Section .
- Spoiler Upper Section
- Removing and installing. Refer to Installing => Spoiler Upper Section .
- Spoiler Lip
- Removing and installing. Refer to ATTACHMENTS, REMOVING AND INSTALLING, AUDI RS5 => Spoiler Lip .
- Front Bumper Cover Noise Insulation
- Removing and installing. Refer to Installing => Bumper Cover End Plate .
- Cover
- For the towing hook
- Lock Carrier Cover
- Removing and installing. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING .
- Bolt
- There are different versions. Refer to the Parts Catalog.
- Quantity: 4
- Tightening specification and sequence. Refer to Fig 2.
- Front Parking Aid Sensor
- Removing and Installing. Refer to Parking Aid .
- Front Bumper Cover Mount
- Removing and installing. Refer to BUMPER GUIDE PIECES, REMOVING AND INSTALLING .
- Nut
- 4 Nm
- Quantity: 4
- Bolt
- 4 Nm
- Quantity: 4
- Front Bumper Cover
- Removing and installing. Refer to BUMPER COVER, REMOVING AND INSTALLING, AUDI RS5 .
- Cover
- For headlamp washer system spray nozzle
- Air Intake Grille
- Removing and installing. Refer to AIR INTAKE GRILLE, REMOVING AND INSTALLING, AUDI RS5 .
- Bolt
- 5 Nm
- Quantity: 4
- Expanding Rivet
- Quantity: 4
- Bolt
- 2 Nm
- Quantity: 2
Lock Carrier Cover - Tightening Specification and Sequence
-- Tighten the bolts in the following order to 3 Nm -2, 3, 5, 1- .