Transfer Fuel Pump -G6-, CHECKING, A5 FROM MY 2012, A4 FROM MY 2013 WITH 4-CYLINDER AND 6-CYLINDER ENGINES, RS5 FROM MY 2012, RS4: Assembling

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Assembly is performed in the reverse order of disassembly, noting the following:

The ignition must be off.

NOTE:

Decrease the fuel pressure by opening the drains -B and C- and letting the fuel run into the measuring container before removing the pressure gauge -1-.

Fig 1: Identifying Shut-Off Valves A And B On Pressure Tester Kit

Courtesy of AUDI OF AMERICA, LLC

-- Remove the Pressure Tester Kit:VAS6550 with the connecting lines.

-- Attach the fuel supply line so that it clicks into place.

-- Press the fuel supply line on again and pull to make sure the connector coupling is engaged correctly.