After-Run Coolant Pump -V51-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Coolant Reservoir for Audi Q5

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Risk Of Scalding Due To Hot Steam And Hot Coolant.

The coolant system is under pressure when the engine is warm.
Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure.

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION .

Fig 2: Automatic Transmission Fluid Oil Pan

Courtesy of AUDI OF AMERICA, LLC

-- Clamp off the coolant hoses -arrows- with the :3094 .

-- Disconnect the connector -2-.

-- Remove the nut -1-.

-- Place the :VAS6208 under the After-Run Coolant Pump -V51-.

-- Disconnect the coolant hoses and After-Run Coolant Pump -V51-.

Fig 3: Identifying Coolant Hoses -Arrows

Courtesy of AUDI OF AMERICA, LLC