Vehicles with Double Clamps Between Center and Rear Mufflers

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Dimension -A- For Retaining Loop

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The center muffler also needs to be aligned on vehicles with clamping sleeves between the center and rear mufflers.

-- Loosen the bolts on the front and rear clamping sleeves.

-- Push the exhaust system far enough forward -arrow- until the preload on the retaining loops in front of the center muffler is -a- = 6 to 10 mm.

-- Tighten the front clamping sleeve threaded connections evenly.

-- Push rear part of exhaust system far enough forward -arrow- so that the pretension at rear retaining loops of rear mufflers is -a- = 11 to 15 mm.

Fig 2: Identifying Dimension -A- For Retaining Loop

Courtesy of AUDI OF AMERICA, LLC

-- Align rear muffler horizontally.

-- Tighten the rear clamping sleeve threaded connections evenly.

-- Align the tail pipes. Refer to TAIL PIPES, ALIGNING .