Oil Pump, Removing And Installing, From VIN CAUA 003 686: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install In Reverse Order Of Removal And Note The Following:

Tightening Specifications. Refer to OVERVIEW - OIL PAN/OIL PUMP .

NOTE:

Replace The Gaskets And O-Rings.

-- Check if both alignment bushings for centering are in the cylinder block.

-- Install the coolant pump. Refer to COOLANT PUMP, REMOVING AND INSTALLING .

-- Install the spur gear unit. Refer to SPUR GEAR DRIVE, REMOVING AND INSTALLING .

-- Install the oil pan lower section. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .

-- Fill with engine oil and check the oil level. Refer to OIL LEVEL, CHECKING

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING - Filling .