8-Cylinder 4.2 FSI Gasoline Engine: Installing
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the new spark plugs using spark plug wrench:VAS 3122B and tighten them to the tightening specification.
-- Lubricate the ignition coils. Refer to IGNITION COIL, LUBRICATING .
-- Align all the ignition coils one after the other and insert them loosely into the spark plug shaft.
-- Press the ignition coils evenly onto the spark plugs by hand. Do not hit them.
-- Connect the connector to the ignition coil until it clicks into place.
-- Tighten the screws to the tightening specification.
-- Installation Is The Reverse Of Removal.
-- Install engine cover. Refer to ENGINE COVER, REMOVING .
| Tightening Specifications | Nm |
|---|---|
| Spark plugs in cylinder head | 30 |
| Connector strip screws | 5 |
| Air filter housing bracket | 9 |