Remove Cylinder Bank 2 (Left)

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

There Different Coolant Reservoirs Installed.

-- Remove the screws -arrows- from the coolant reservoirs.

Fig 1: Identifying Coolant Reservoir

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector from the engine coolant level warning switch -F66- at the bottom of the coolant reservoir and move the coolant reservoir to the side with the coolant hoses -1 through 3- still connected.

-- Remove the screw -arrow- from the coolant reservoir.

Fig 2: Identifying Coolant Hoses At Coolant Expansion Tank

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector for the Engine Coolant Level (ECL) Warning Switch -F66- on the bottom of the coolant reservoir and move the reservoir with the coolant hoses still connected -1- and -2- to the side.

-- Remove the screws -arrows- from the connector strip.

Fig 3: CMP Sensor And Exhaust Camshaft Control Valve Cylinder Bank 2 (Left Side)

Courtesy of AUDI OF AMERICA, LLC

-- Push the connector toward the ignition coil, open the lock by hand and connect the connector to the ignition coils.

-- Move the wiring harness slightly down.

NOTE:

Ignore -1 through 3-.

Continuation For Both Sides:

-- Place the ignition coil puller:T40039 only on the top rib -arrow- and pull the ignition coils one after the other off the spark plugs.

Fig 4: Identifying Ignition Coil Puller - T40039-

Courtesy of AUDI OF AMERICA, LLC

-- Remove spark plugs using spark plug wrench:VAS 3122B .