Version 1 Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING .

-- Remove the screws -1- from the connector strip.

Fig 1: Identifying Bolts And Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Push the connector -2- toward the ignition coil, open the retainer by hand and disconnect the connector.

-- Place the ignition coil puller:T40039 only on the top rib -arrow- and pull the ignition coils one after the other off the spark plugs.

Fig 2: Identifying Ignition Coil Puller - T40039-

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Note The Installed Position Of Ignition Coils With Power Output Stages.

Be Careful To Not Kink Or Damage The Wiring.

-- Remove spark plugs using spark plug wrench:VAS 3122B .