Overview - Cover And Cushion, Rear Seat Backrest With Backrest Frame Cover Or Storage Compartment
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Illustration Only Shows The Structure Of The Right 2/3 Section Of The Backrest. The Structure Of The Left 1/3 Section Of The Backrest Is Similar.
Fig 1: Exploded View Of Cover And Cushion, Rear Seat Backrest With Backrest Frame Cover Or Storage Compartment
- Trim
- For Locking
- Lock Cylinder without Trim, Removing and Installing. Refer To LOCKING MECHANISM TRIM, REMOVING AND INSTALLING, LOCKING MECHANISM WITHOUT LOCK CYLINDER .
- Lock Cylinder with Trim, Removing and Installing. Refer To LOCKING MECHANISM TRIM, REMOVING AND INSTALLING, LOCKING MECHANISM WITH LOCK CYLINDER .
- Headrest Guide
- Removing and installing. Refer To HEADREST GUIDE, REMOVING AND INSTALLING .
- Backrest Shell
- Outer Bracket
- Release Cable
- Lock - Connector Station
- Inner Bracket
- Upper Padding
- Removing and installing. Refer To UPPER AND LOWER CUSHION, REMOVING AND INSTALLING, BACKREST WITH BACKREST BRACKET COVER OR STORAGE COMPARTMENT .
- Cushion
- Removing and installing. Refer To COVER AND PADDING, REMOVING AND INSTALLING, REAR SEAT BACKREST WITH REAR SEAT BACKREST FRAME OR STORAGE COMPARTMENT .
- Separate the cover from the padding. Refer To COVER AND PADDING, SEPARATING, REAR SEAT BACKREST WITH REAR SEAT BACKREST FRAME COVER OR STORAGE COMPARTMENT
- Clip
- Covered In Foam Padding
- Clip
- Covered In Foam Padding
- Only With Fabric Covers
- Cover
- Removing and installing. Refer To COVER AND PADDING, REMOVING AND INSTALLING, REAR SEAT BACKREST WITH REAR SEAT BACKREST FRAME OR STORAGE COMPARTMENT .
- Separate the cover from the padding. Refer To COVER AND PADDING, SEPARATING, REAR SEAT BACKREST WITH REAR SEAT BACKREST FRAME COVER OR STORAGE COMPARTMENT
- Cushion Clip
- Only With Leather Covers
- For Securing The Cover To The Padding
- Always Replace If Removed
- Install In Same Location As Before Removal
- Retaining Channel
- Sewn Into Cover
- For Engaging The Cover In The Backrest Shell
- Molding
- Only On Backrest With Storage Compartment Or Backrest Back Cover, 2/3 Right Side
- Sewn Into Cover
- For Attaching The Cover Into The Storage Compartment Cut-Out Or The Backrest Cover
- Molding
- Sewn Into Cover
- For Engaging The Cover In The Backrest Shell
- Plugs
- For Securing The Cover
- Quantity: 2
- Lower Padding
- Removing and installing. Refer To UPPER AND LOWER CUSHION, REMOVING AND INSTALLING, BACKREST WITH BACKREST BRACKET COVER OR STORAGE COMPARTMENT .