Cover And Padding, Removing And Installing, Rear Seat Backrest With Pass-Through: Removing

-- Remove The Bench Seat. Refer To SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .

-- Remove The Backrest. Refer To REAR SEAT BACKREST, REMOVING AND INSTALLING .

-- Remove The Headrests. Refer To HEADREST, REMOVING AND INSTALLING .

Right 2/3 Section Of Backrest With Pass-Through: 

-- Remove The Center Armrest With The Pass-Through Cover. Refer To CENTER ARMREST, REMOVING AND INSTALLING, CENTER ARMREST WITH PASS-THROUGH DOOR HANDLE, INNER HINGE .

-- Remove The Cover Frame. Refer To COVER FRAME, REMOVING AND INSTALLING .

Continuation For Left And Right Backrest: 

Fig 1: Identifying Backrest Plugs & Bracket

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Retainer Trim: 

• Refer To LOCKING MECHANISM TRIM, REMOVING AND INSTALLING, LOCKING MECHANISM WITHOUT LOCK CYLINDER .
• Refer To LOCKING MECHANISM TRIM, REMOVING AND INSTALLING, LOCKING MECHANISM WITH LOCK CYLINDER .

-- Remove Headrest Guide. Refer To HEADREST GUIDE, REMOVING AND INSTALLING .

-- Unclip The Plugs -2-.

1  - Cover

3  - Inner Bracket

-- Pry The Upper Retaining Channel -1- Out Of The Backrest Shell -3-.

Fig 2: Pry Upper Retaining Channel

Courtesy of AUDI OF AMERICA, LLC

-- Remove The Molding -2- From The Sides And Bottom Of The Backrest Shell -3-.

Right 2/3 Section Of Backrest With Pass-Through: 

Fig 3: Pry Off Piping

Courtesy of AUDI OF AMERICA, LLC

-- Pry Off Molding -1 And 3- In Backrest Pass-Through -2-.

Continuation For Left And Right Backrest: 

-- Pry The Cover Over The Inner Bracket.

-- Pry The Cover Over The Outer Bracket.

-- Guide The Release Cable With The Connector Station Through The Slit In The Cover.

-- Remove The Cover With Padding From The Backrest Shell.