Hydraulic Fluid Cooler To The Condenser - RS Models

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Hydraulic Fluid Cooler -1- & Bolts -2-

Courtesy of AUDI OF AMERICA, LLC

-- Mount the hydraulic fluid cooler -1- on the retainers and tighten the bolts -2- to 9 Nm.

Lines to the hydraulic oil cooler. Refer to HOSE LINES TO RESERVOIR, HYDRAULIC FLUID COOLER AND RETURN LINE INSTALLED POSITION .

Pressurized Line To Crossbrace

Fig 2: Identifying Pressurized Line To Crossbrace

Courtesy of AUDI OF AMERICA, LLC

-- Install the pressure line on the crossbrace using the nut -3- and rubber bushing -4-.

-- Note the line installation location when bolting the line connection. The markings -1 and 2- must be opposite each other.

Return Line Bracket To The Subframe

Fig 3: Return Line Bracket to the Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Secure the return line -2- with the line bracket -1- to the left front of the subframe -3-.

-Arrow- Points In Direction Of Travel.

Return Line To Subframe

Fig 4: Identifying Return Line To Subframe

Courtesy of AUDI OF AMERICA, LLC

-- Install the return line -4- on the subframe -3- using the bracket -2- and bolt -1-.