Hydraulic Oil Cooler, Removing And Installing, 8-Cylinder FSI, With Dynamic Steering: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bolts -1, 2, 3 and 5- and remove the front lock carrier cover -4-. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING / OVERVIEW - LOCK CARRIER .

Fig 1: Front Lock Carrier Cover

Courtesy of AUDI OF AMERICA, LLC

-- Lift the lock carrier cover -4- -arrow- and disengage it from the radiator grille. Refer to LOCK CARRIER COVER, REMOVING AND INSTALLING / OVERVIEW - LOCK CARRIER .

-- Clamp off the hydraulic lines -5 and 6- with the :3094 .

Fig 2: Hydraulic Oil Cooler, Vehicles With Dynamic Steering (1 Of 2)

Courtesy of AUDI OF AMERICA, LLC

-- Remove the clamping sleeves -3 and 4-.

Fig 3: Hydraulic Oil Cooler, Vehicles With Dynamic Steering (1 Of 2)

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the hydraulic lines -5 and 6- from the hydraulic oil cooler.

-- Release the retaining tabs -3-, tilt the hydraulic oil cooler -1- forward slightly and remove it from the mounts -2- on the A/C condenser.

Fig 4: Hydraulic Oil Cooler To Condenser

Courtesy of AUDI OF AMERICA, LLC