HEADLAMP, REMOVING AND INSTALLING, HALOGEN HEADLAMP, From MY 2013: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Headlamp Housing Remove/Install Components

Courtesy of AUDI OF AMERICA, LLC

-- Turn the light switch to position "0".

-- Turn off the ignition and all electrical equipment and remove the ignition key.

-- Do not operate the headlamp flasher.

-- Remove The Front Bumper Cover. Refer To FRONT - BUMPER COVER, REMOVING AND INSTALLING .

-- Disconnect the connector -2-.

-- Remove the bolts -1 and 4-.

-- Remove the bolt -3- and remove the adjusting mechanism from the headlamp housing.

-- Loosen the screws -arrows- a few turns from the headlamp housing.

-- Remove the headlamp -5- toward the front from the body.

The ventilation hose may need to be removed from the bracket to do this depending on the date of manufacture.