Remove Mounting Grommets -2- From The Body Opening And Throw Away.

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove Mounting Grommets -2- From The Body Opening And Throw Away.

Fig 1: Check Floor Panel For Deformation And Adjust If Necessary

Courtesy of AUDI OF AMERICA, LLC

-- Check the floor panel for deformation and adjust if necessary. Refer To FLOOR PANEL FOR BENCH SEAT MOUNTING GROMMETS AND WIRE FRAME, CHECKING AND ALIGNING .

-- Check the wire frame for deformation and adjust if necessary. Refer To FLOOR PANEL FOR BENCH SEAT MOUNTING GROMMETS AND WIRE FRAME, CHECKING AND ALIGNING .

-- Lift floor covering -3- and press in new mounting grommets -2- until they engage audibly in body opening -1-.

-- Place floor covering -3- around grommet -2- as shown.

NOTE:

Floor Covering -3- May Not Be On Grommet -2-.

Make sure the seat heating electrical collections slide on and engage audibly.

-- Insert Bench Seat -1- And Press Wire Frame -2- "Firmly" Into Grommets -3-.

Fig 2: Insert Bench Seat And Press Wire Frame "Firmly" Into Grommets

Courtesy of AUDI OF AMERICA, LLC

-- Ensure That Wire Frames -2- Are Engaged Correctly In Grommets -3-.

NOTE:

The Bench Seat Must Finally Be Checked For Secure Fit.

-- For this purpose, grab with both hands under the seat frame on one side of the seat in direction of -A arrows- and pull evenly >>not abruptly<< upward with a force of approx. 100 to 150 N >>i.e., approx. 10 to 15 kg<<.

-- Repeat the procedure on the other side in direction of -B arrows-.

NOTE:

The Bench Seat Must NOT Disengage From The Grommets.

-- If the bench seat does disengage, the entire procedure must be repeated. Refer To SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .