Overview - Center Armrest, Center Armrest With Pass-Through Door

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Center Armrest, Backrest With Pass-Through Exploded View

Courtesy of AUDI OF AMERICA, LLC

2/3 Right Backrest
- With pass-through
- Equipment levels
Cover Frame
- Clipped into the rear seat backrest
- Removing and installing. Refer To COVER FRAME, REMOVING AND INSTALLING .
Door
- For pass-through
- Removing and installing. Refer To PASS-THROUGH COVER, REMOVING AND INSTALLING .
Lock Washers
- Quantity: 2
- For bolt -item 6-
Bracket
- Part of the center armrest and pass-through cover
- Is not removed individually
Bolts
- 8 Nm
- Quantity: 2
Bolt
- 11 Nm
- Always replace if removed
- Self-locking
- Quantity: 4
Center Cushion
- Removing and installing. Refer To CENTER CUSHION, REMOVING AND INSTALLING .
Center Armrest
- Removing and installing. Refer To CENTER ARMREST, REMOVING AND INSTALLING, CENTER ARMREST WITH PASS-THROUGH DOOR HANDLE, OUTER HINGE .
Trim
- For the cupholder
- Removing and installing. Refer To CUPHOLDER TRIM, REMOVING AND INSTALLING .
Cupholder
- Removing and installing. Refer To CUPHOLDER, REMOVING AND INSTALLING .
Key
Install The Lock Cylinder
- For the pass-through cover
- Removing and installing. Refer To LOCK CYLINDER, REMOVING AND INSTALLING, PASS-THROUGH DOOR HANDLE .
  CAUTION:
  - Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.
  - Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.
Protective Cap
- For lock cylinder
- Remove before installing the lock cylinder
  CAUTION:
  The Key Must Be Inserted In The Lock Cylinder Correctly Before The Protective Cap Is Removed. If That Is Not Done, The Tumblers And Compression Springs Can Fall Out And The Lock Cylinder Will Be Ruined.