Driver Side Knee Airbag With Igniter, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING .

-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY .

-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING, VEHICLE WITH KNEE AIRBAGS .

Fig 1: Disengaging Driver Side Knee Airbag From Hook -2- & Tab -7- & Remove It Downward

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Disconnect the connector -3-.

-- Pull the retainer -2- in the direction of the -arrow- and disconnect the connectors -1 and 3-.

Fig 2: Pulling Locking Mechanism And Disconnecting Electrical Harness Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1, 4, 5 and 8-.

Fig 3: Disengaging Driver Side Knee Airbag From Hook -2- & Tab -7- & Remove It Downward

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the driver side knee airbag from the hook -2- and the tab -7- and remove it downward.

-- Lay the driver knee airbag so the padding faces up.