Overview - Driver Side Airbag, Attached Airbag Version
WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Locking Bracket
- Use a T25 TORX screwdriver, approximately 100 mm long
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138- and Steering Angle Sensor -G85-
- Overview. Refer to SENSORS
- 4-Spoke Steering Wheel
- Equipment levels
- Overview. Refer to OVERVIEW - STEERING WHEEL .
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all pyrotechnic components safety precautions. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .
- 3-Spoke-Steering Wheel
- Equipment levels
- Overview. Refer to OVERVIEW - STEERING WHEEL .
- Wiring Harness
- For the Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Replacing. Refer to AIRBAG CONNECTOR, REPLACING .
- Press in to secure in the pockets on the steering wheel.
- Driver Side Airbag
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-WARNING:
Follow all pyrotechnic components safety precautions. Refer to PYROTECHNIC COMPONENTS SAFETY PRECAUTIONS .
- Removing and installing. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .
- With Driver Airbag Igniter -N95- and Driver Airbag Igniter 2 -N250-
- Bolt
- Tightening specification. Refer to OVERVIEW - STEERING WHEEL .