LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S4 Premium Plus, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 1101 (Passenger Protection, Airbags, Seat Belts (Coupe)) >> 69 Passenger Protection, Airbags, Seat Belts >> Belt Fastening Detection >> Front Passenger Occupant Detection Sensor -G128-, REMOVING AND INSTALLING >> Removing

Front Passenger Occupant Detection Sensor -G128-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 23 other vehicles, including the 2017 Audi S5, 2017 Audi A5 Quattro, 2016 Audi S5, 2016 Audi A5 Quattro, and 2015 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS .
  • Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Turn on the ignition.

-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY .

-- Remove the front seat on the passenger side:

-- Attach the front seat to the Engine/Transmission Holder - Seat Repair Fixture:VAS6136  . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Separate the cover from the padding (seat pan). Refer to SEAT PAN COVER AND CUSHION, SEPARATING, SEAT PAN WITHOUT SEAT DEPTH ADJUSTER .

NOTE:

Remove the upholstery from the rear part of the cover until the seat occupied sensor is freed up.

Standard Seat and Sport Seat (Manual or Power):

Fig 1: Identifying Seat Occupant Sensor, Removal
GWWA69-10410Courtesy of AUDI OF AMERICA, LLC

-- Remove the passenger occupant detection system connector -2-.

-- Carefully remove passenger occupant detection system sensor -2- including circuit board -4- from seat cushion -1-.

Comfort Seat:

Fig 2: Warming Heating Element With Tool VAS 1978/14
GWWA69-10386Courtesy of AUDI OF AMERICA, LLC

-- Carefully warm up the seat heating element -1- on the left side using the Wiring Harness Repair Set - Hot Air Blower:VAS1978/14A  .

-- Remove the seat heating element -2- in direction of -arrow- until the seat occupied sensor -1- is freed up.

Fig 3: Identifying Seat Heating Element, Removal
GWWA69-10387Courtesy of AUDI OF AMERICA, LLC

-- Remove the passenger occupant detection system connector.

Fig 4: Identifying Seat Occupant Sensor, Removal
GWWA69-10388Courtesy of AUDI OF AMERICA, LLC

-- Carefully remove seat occupant sensor -4- including circuit board -3- from seat cushion -1-.

Super Sport Seat:

Fig 5: Identifying Seat Occupied Sensor Connector
GWWA69-10411Courtesy of AUDI OF AMERICA, LLC

-- Remove the passenger occupant detection system connector -2-.

-- Carefully remove passenger occupant detection system sensor -2- including circuit board -4- from seat cushion -1-.

scientia non olet · About LEMON Manuals