Overview - Headlamp, Halogen Headlamps (From My 2013)

Note the information about contact corrosion. Refer to CONTACT CORROSION .

Part 1 - Headlamp housing, bulbs, control modules 

Fig 1: Overview Of Headlamp, Halogen Headlamps (From MY 2013)

Courtesy of AUDI OF AMERICA, LLC

1. Sealing Frame
   • Removing and installing. Refer to SEALING FRAME, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
2. Ventilation
   • For the headlamp housing
   • There are different versions.
3. Headlamp Housing Inner Bracket
   • Removing and installing. Refer to HEADLAMP HOUSING INNER BRACKET, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
4. Screw
   • 4.5 Nm
5. Screw
   • 6 Nm
   • Quantity: 2
6. Front Turn Signal Bulb
   • Left Front Turn Signal Bulb -M5-
   • Right Front Turn Signal Bulb -M7-
   • Removing and installing. Refer to LEFT/RIGHT FRONT TURN SIGNAL BULB -M5- / -M7-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
7. High Beam Headlamp Bulb
   • Left High Beam Headlamp Bulb -M30-
   • Right High Beam Headlamp Bulb -M32-
   • 12 V, 55 W (H7)
   • Bulb, replacing. Refer to LEFT/RIGHT HIGH BEAM HEADLAMP BULB -M30- / -M32-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
8. Screw
   • 4.5 Nm
9. Housing Cover
10. Impact Screw
    • For aligning headlamp housing to contour of chassis
    • Must touch lock carrier
11. Headlamp Housing Upper Bracket
    • Removing and installing. Refer to HEADLAMP HOUSING UPPER BRACKET, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
12. Screw
    • 4.5 Nm
13. Spring Nut
14. Screw
    • 4.5 Nm
15. Housing Cover
16. Low Beam Headlamp Bulb
    • Left Low Beam Headlamp Bulb -M29-
    • Right Low Beam Headlamp Bulb -M31-
    • 12 V, 55 W (H7)
    • Bulb, replacing. Refer to LEFT/RIGHT LOW BEAM HEADLAMP BULB -M29- / -M31-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
17. Adjuster
    • For adjusting the headlamp housing to the bumper contour
18. Position Lamp/Daytime Running Lamp Bulb
    • Left Position Lamp Bulb -M1-
    • Right Position Lamp Bulb -M3-
    • Bulb, replacing. Refer to LEFT/RIGHT POSITION LAMP BULB -M1- / -M3-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
    • Left Daytime Running Lamp Bulb -L174-
    • Right Daytime Running Lamp Bulb -L175-
    • 12 V, 26 W (PSX26W)
    • Bulb, replacing. Refer to LEFT/RIGHT DAYTIME RUNNING LAMP BULB -L174- / -L175-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
19. Side Marker Lamp Power Output Stage
    • Left Side Marker Lamp Power Output Stage -J986-
    • Right Side Marker Lamp Power Output Stage -J987-
    • Removing and installing. Refer to LEFT/RIGHT SIDE MARKER LAMP POWER OUTPUT STAGE -J986- / -J987-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
20. Headlamp Housing
    • Removing and installing. Refer to HEADLAMP, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .

Part 2 - Repair Kit

Fig 2: Overview Of Headlamp Beam Adjustment Motor And Cover

Courtesy of AUDI OF AMERICA, LLC

1. Headlamp Housing
   • Removing and installing. Refer to HEADLAMP, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
2. Headlamp Beam Adjustment Motor
   • Left Headlamp Beam Adjustment Motor -V48-
   • Right Headlamp Beam Adjustment Motor -V49-
   • Removing and installing. Refer to LEFT/RIGHT HEADLAMP BEAM ADJUSTMENT MOTOR -V48- / -V49-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
3. Headlamp Beam Adjustment Motor Housing Cover
   • The headlamp housing must be cut open to replace the adjustment motor
   • A housing cover can be ordered to seal the assembly opening.
   • Removing and installing. Refer to LEFT/RIGHT HEADLAMP BEAM ADJUSTMENT MOTOR -V48- / -V49-, REMOVING AND INSTALLING, HALOGEN HEADLAMPS FROM MY 2013 .
4. Screw
   • 2 Nm
   • From the repair kit for the headlamp range control adjustment motor cover
   • Quantity: 2
5. Screw
   • 1.4 Nm
   • Quantity: 2