Front Level Control System Sensor -G78- / -G289-, Removing And Installing: Installing

Installation is the reverse of removal, with special attention to the following:

NOTE:

The level control system sensor lever must point toward vehicle exterior.

The thread on the level control system sensor must be installed in the front hole in the control arm. The tab on the level control system sensor must fit into the rear hole to assure that the installation position is correct.

On vehicles with electronically controlled damping (Audi magnetic ride), perform the function "Adapt the Control Position" with the Vehicle Diagnostic Tester.
If the control position was reprogrammed and if the vehicle has lane assist, then it will then be necessary to calibrate the driver assistance systems front camera. Refer to DRIVER ASSISTANCE SYSTEMS FRONT CAMERA, CALIBRATING .
Perform the basic setting of the headlamps. Refer to HEADLAMPS .