Part II
WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
For Valvetrain, Engine With One Camshaft Adjusters - Part I. Refer to PART I .
- Cylinder Head
- Ball Pin
- For the engine cover
- 9 Nm
- O-ring
- Always replace after removing
- Coat with engine oil
- Plugs
- Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Fig 2.
- Seal
- Always replace after removing
- Vacuum Pump
- Overview. Refer to VACUUM SYSTEM .
- Bolt
- Tightening specification. Refer to VACUUM SYSTEM .
- Seal
- Always replace if damaged
- O-ring
- Always replace after removing
- Coat with engine oil
- Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
- Bolt
- Tightening specification 13) OVERVIEW - IGNITION SYSTEM - Bolt
- Bolts
- 9 Nm
- Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-