EGR Temperature Sensor -G98-, Removing And Installing: Removing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- If installed: Disconnect the vacuum hose -arrow- and free it up.
CAUTION:
- Do not open the hose connection on the crankcase ventilation.
Do not open the crankcase ventilation hose connection -1-. Only the other side of the hose connection may be opened.
-- Free up the vacuum hose on the air guide pipe -arrows-.
-- Remove bolt -2- and tilt the air guide pipe with the intake tube backward and remove from the turbocharger.
- Do not cut the wire connection.
-- Disconnect the connector -2- and free up the wire.
-- Remove the EGR Temperature Sensor -G98- -1-.