Overview - Bevel Box Components
Courtesy of AUDI OF AMERICA, LLC
- Seal
- Bevel Box
- Oil Drain Plug
- Tightening Specification:
- Threads greased: 11 Nm
- Threads dry: 20 Nm
- Always replace after removing
- With permanent seal
- Oil Filler Plug
- Tightening Specification:
- Threads greased: 11 Nm
- Threads dry: 20 Nm
- Always replace after removing
- With permanent seal
- Seal
- Bleed Pipe
- For bleeding the bevel box
- Press it in until it stops
- Cap
- For bleeding the bevel box
- Right Flange Shaft
- Seal
- Insert into the surrounding right flange shaft groove
- Remove to replace the needle bearing (polygon bearing) -10-.
- Needle Bearing (Polygon Bearing)
- Circlip
- Always replace after removing
- Twelve-Point Nut
- Bevel Box Output Flange
- Shim
- Seal
- Tapered Bearing Inner Race
- Bolt
- Pinion Housing
- With shaft bevel gear and outer race for tapered roller bearing
- No replacement part
- Carefully pry out, alternating from side to side
- Note the fastening holes; the pinion housing fits only in one position
- O-ring
- To replace, remove the bolts -17- and carefully pry out the pinion housing at the notches in the pinion housing.
- Do not remove the twelve-point nut -12- and the output flange -13-.
- Shim
- No replacement part
- Note the bevel box fastening holes; the shim fits only in one position
- Cap