Dual Clutch, Installing: Notes

Special tools and workshop equipment required

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.

Mandatory Replacement Parts

Brief Description

Adjust the clutch axial play when installing.
Secure the transmission to the assembly stand so that it is vertical when removing and installing the clutch. This is the only position in which the clutch axial play can later be adjusted without malfunctions.
The large clutch plate carrier is inserted in all clutch discs in the clutch. The large clutch plate carrier must not slide out of the lowest plate.
Oil pump shaft is removed.
Do not install any wavy circlips
The drive plate (upper section of the dual clutch) of a new clutch is not secured with the circlip, it only sits "taut" in the clutch.
The drive plate must remain engaged between the teeth of the outer clutch plate carrier.
If the drive plate is loosened, the plates in the dual clutch can slip out of place and it cannot be adjusted correctly during installation under the circumstances.