After-Run Coolant Pump -V51-, Removing And Installing - Laying At Top: Removing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

During installation, install all heat insulation sleeves at the same locations.

WARNING:

The cooling system is under pressure when the engine is warm. Risk of scalding due to hot steam and hot coolant.

Scalding the skin and other parts of the body is possible.

Wear safety gloves.
Wear protective eyewear.
Reduce the pressure by covering the coolant expansion tank cap with a cloth and carefully opening it.

-- Open the coolant reservoir cap -arrow-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION / NOISE INSULATION, REMOVING AND INSTALLING .

-- If equipped remove the noise insulation -1-. Refer OVERVIEW - NOISE INSULATION / NOISE INSULATION, REMOVING AND INSTALLING to .

Courtesy of AUDI OF AMERICA, LLC

Vehicles With Dual-Clutch Transmission 0D9:

Courtesy of AUDI OF AMERICA, LLC

-- Remove the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Loosen the hose clamp -1-, remove the air duct hose from the charge air cooler.

Vehicles with Left Auxiliary Radiator:

Courtesy of AUDI OF AMERICA, LLC

-- Free up the coolant hose -3-.

-- Free up the wiring harness -1 and 2- from the air duct pipe.

-- Loosen the screw-type clamp -4-.

-- Remove the bolts -arrows- and remove the air duct pipe.

Continuation For All Vehicles:

Courtesy of AUDI OF AMERICA, LLC

-- Open the heat shield boot -3-.

-- Disconnect the connector -1-.

-- Clamp off the coolant hoses at the After-Run Coolant Pump -V51- using :3094 .

NOTE:

Place a cloth underneath to catch any leaking coolant.

-- Loosen the hose clamps -arrows- and remove the coolant hoses.

-- Remove the bolt -2- and the After-Run Coolant Pump -V51-.