Vibration Damper Seal, Replacing: Procedure: Removing
WARNING: This page is about a different car, the 2016 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .
-- Remove the seal -arrow- with the :T40274 .
-- Clean the contact and sealing surface.
-- Push the seal -arrow- on the :T10354 .
- The closed side of the seal points to the :T10354 .
-- Push the seal -arrow- with the :T10354 on the :T10531/2 and place on the lower timing chain cover.
-- Additionally attach the :T10375 and tighten the :T10531/4 .
-- Drive the seal in all the way using the :T10354 .