Pressing The Sensor Wheel On Again:

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Secure the :T10134 on the crankshaft flange.

-- Pay attention that the :T10134 locating pin is seated in the sensor wheel hole.

-- Tighten the hex socket bolts -E- hand-tight.

-- Push the :T10134 by hand to the sealing flange -1-.

-- Install the nut -B- as far as possible on the threaded spindle by hand until it touches the :T10134 .

-- Insert the guide pin for diesel engines (black handle) -G- in the crankshaft flange.

-- Install two M6 x 35 bolts -2- for guiding the sealing flange -1- into the cylinder block.

-- Tighten the :T10134 nut -B- to 40 Nm.

Courtesy of AUDI OF AMERICA, LLC

-- Check the sensor wheel installation position on the crankshaft one more time. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH SIX CONNECTION AREAS .

-- Tighten the nut on the :T10134 to 45 Nm if the measured value is too small.

-- Check the sensor wheel installation position on the crankshaft one more time. Refer to TRANSMISSION SIDE SEALING FLANGE, REMOVING AND INSTALLING, CRANKSHAFT FLANGE WITH SIX CONNECTION AREAS .