Crankshaft Needle Bearing, Replacing: Installing
WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- The side of needle bearing with writing on it must be readable when installed.
-- Clean the bearing seat in the crankshaft and apply a thin coat of grease.
-- With :VW207C or :3176 .
Installation Depth Dimension a = 2.0 mm
NOTE:
If the needle bearing is unintentionally pushed in to deeply, it must be replaced, because it will be damaged when it is removed again.