Transmission Mount, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A3 and 2015 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Replace the bolts that were tightened with an additional turn.

-- Secure the transmission support to the longitudinal member.

-- Lift the transmission using the engine support bridge spindle until the transmission support touches the support arm.

The transmission support and the transmission support arm must be absolutely parallel to each other before installing the bolts.
Push the rear of the transmission upward using a floor jack if necessary.

-- Tighten the subframe mount bolts.

-- Check the adjustment of the assembly mounts. Refer to SUBFRAME MOUNT, CHECKING ADJUSTMENT .

-- Remove the :10-222A from the engine.