Charge Air Pressure Actuator -V465-, REMOVING AND INSTALLING: Removing

Observe the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Vehicles with a particulate filter 

-- Remove the particulate filter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, VEHICLES WITH PARTICULATE FILTER .

AWD vehicles without particulate filter. 

-- Remove the catalytic converter. Refer to CATALYTIC CONVERTER, REMOVING AND INSTALLING, VEHICLES WITHOUT PARTICULATE FILTER .

FWD vehicles without particulate filter. 

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the clamping sleeve -arrow-.

-- Remove the bolts -arrows-.

-- Press the catalytic converter together with the front exhaust pipe to the side.

Continuation for All Vehicles 

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -4-.

-- Loosen the lock nut -2- a quarter turn, to do so counterhold on the control rod hex fitting -arrow-.

-- Remove the control rod from the operating lever -1- at the same time do not turn the lock nut.

-- Remove the bolts -3- and then the Charge Air Pressure Actuator -V465-.