LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> RS 7 Performance >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System (Cylinder Head & VALVETRAIN - Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC) >> Cylinder Head, VALVETRAIN >> VALVETRAIN >> Overview - VALVETRAIN >> Tightening Specifications

Tightening Specifications

GWWA15-12254
NOTE:

Replace the bolts that were tightened with an additional turn.

-- Tighten the bolts in steps in the sequence shown:

Step Bolts Tightening Specification/Additional Turn
1. -1 to 21- Install all the way in by hand.
  • The camshaft housing contact surface must lay entirely on top of the cylinder head
2. -1 to 21- 8 Nm
3. -1 to 21- Tighten an additional 90°
scientia non olet · About LEMON Manuals