Cylinder Bank 2 (Left)

1. Intake camshaft
2. Exhaust camshaft

• The surfaces with the threaded openings -arrows- must face a little towards the right and towards the engine center.
• The camshafts almost set themselves into the correct position.

-- Bring the camshaft spacers into the installed position -arrows- :

• The spacers must be slid respectively towards the center of the camshafts.

-- Apply sealant beads -1 and 2- to the clean camshaft housing surfaces as shown in the illustration.

• Thickness of sealant beads: 2.5 mm.