Cylinder Bank 2 (Left):

-- Attach both of the camshaft adjusters without camshaft timing chains to the cylinder head and then loosely screw on the bolts -1 and 2-.

-- Position the :T40269  onto the camshaft adjuster for the left intake camshaft and counterhold with a wrench -2-.

-- Tighten the bolt -1- by hand.

-- Turn the intake camshaft with the wrench counterclockwise until the thread for the camshaft clamp is in the lower center of the camshaft housing opening.

-- Tighten the left bolt -arrow left- on the :T40264/2  .

-- Position the :T40269  onto the camshaft adjuster for the left exhaust camshaft and counterhold with a wrench -2-.

-- Tighten the bolt -1- by hand.

-- Turn the exhaust camshaft with the wrench counterclockwise until the thread for the camshaft clamp is in the lower center of the camshaft housing opening.

-- Tighten the right bolt -right arrow- on the :T40264/2  .

-- Remove the bolts -1 and 2- by counterholding with the wrench and the :T40269  . Remove the camshaft adjuster.