ATF Level In Rear Final Drive 0BF And 0BE, Checking
Test Requirement
- ATF temperature: 10 °C to 60 °C (50 °F to (140 °F)
- The rear final drive must be in the installed position.
- The vehicle must be level.
Special tools and workshop equipment required
- Drip Tray
-- Remove the ATF check plug -1- to check the ATF level.
CAUTION:
- The ATF check plug -1- is located on the left side of the rear final drive. Identification >>ATF<< on the final drive housing -arrow-
- ATF sealing plug overview. Refer to OVERVIEW - DRAIN AND INSPECTION PLUG FOR ATF AND GEAR OIL, REAR FINAL DRIVE 0BF AND 0BE .
- The ATF level is correct when the rear final drive is filled to the lower edge of the fill hole.
If the ATF is correct:
-- Install the new ATF check plug and fasten. Tightening specification -item 12- OVERVIEW - REAR FINAL DRIVE.
If the ATF is not correct:
-- Fill with ATF. Refer to ATF ON REAR FINAL DRIVE 0BF AND 0BE, FILLING .