Flange Shaft Ring, Replacing, 0BE, 0BF

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The ring can only be replaced with the final drive and the flange shaft removed.

Special tools and workshop equipment required

Thrust Plate VW 401
Thrust PlateVW 402
Punch VW 412
Sleeve 40 - 21
Seal Press Sleeve 2003/1 from the Seal Installer 2003
Press Tube 3345
-3- Separating Tool 22 to 115 mm, for example, Kukko Separating Tool 22-115 mm17/2

The rear final drive is removed. Refer to FINAL DRIVE .
Flange shaft removed. Refer to LEFT SEAL, REPLACING, 0BE, 0BF .

Fig 1: Identifying Ring -A- To Flange Shaft, Removal

Courtesy of AUDI OF AMERICA, LLC

B - Separating device 22 to 115 mm, for example Kukko Separating Tool 22-115 mm17/2

Fig 2: Carefully Install Ring -A- Onto Flange Shaft

Courtesy of AUDI OF AMERICA, LLC

Protective ring installation location -A- : The larger outer circumference on the protective ring faces the Press Tube3345.