All Wheel Drive Pump -V415-, 0BE, 0BF: Installing
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2015 Audi RS 7, 2015 Audi A7 Quattro, 2014 Audi S7, 2014 Audi RS 7, and 2014 Audi A7 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The hydraulic pump -A- is installed inside the hydraulic control unit. Assembling the hydraulic pump, refer to Figure.
- The adapter -B- is installed in the recesses in the hydraulic pump.
- A new O-ring -D- is on the All Wheel Drive Pump -V415-.
-- Install the All Wheel Drive Pump -V415- with the coupling -C- in the adapter -B-.
-- Diagonally tighten the 4 bolts on the All Wheel Drive Pump -V415- -2- to the tightening specification -item 1- in HYDRAULIC CONTROL UNIT, 0BE, 0BF .
-- Connect the connector -1- to the All Wheel Drive Pump -V415-.
-- Fill the ATF in the rear final drive. Refer to ATF, FILLING, 0BE, 0BF .