Input Shaft Ball Bearing, Replacing: Removing

WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dual clutch -1-. Refer to DSG CLUTCH, REMOVING .

-- Remove the locking ring -arrow- from the removed clutch cover.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the dual clutch ball bearing.

Courtesy of AUDI OF AMERICA, LLC

NOTE:

There may still be a thrust washer -2- behind the ball bearing -3- depending on the clutch cover date of manufacture. If there is, then replace the old one with a new one when installing the new ball bearing.

Courtesy of AUDI OF AMERICA, LLC

Replace the ball bearing -3-.