Input Shaft Ball Bearing, Replacing: Installing
WARNING: This page is about a different car, the 2018 Audi S7, 2017 Audi S7, and 2016 Audi S7. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Replace the O-ring and locking rings. Refer to OVERVIEW - FLYWHEEL AND DUAL CLUTCH .
NOTE:
The clutch cover may have or may not have a thrust washer -2-, depending on the date of manufacture.
-- If it was there during the removal, then insert a thrust washer -2- into the cover -1-.
-- Install the new dual clutch ball bearing all the way.
- Position the Press Piece - 60mm :VW415A with the thin shoulder facing up.
-- Install the new ball bearing circlip -arrow-.
-- Clean the sealing surface on the clutch cover.