LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> RS 7 Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Turbocharger System (Service Information - 4.0L - CEUC, CRDB, CTGE, CWUB, CWUC) >> Turbocharger, Supercharger >> Charge Air System >> Charge Air Cooler, Removing And Installing >> Installing

Charge Air Cooler, Removing And Installing: Installing

Install in reverse order of removal. Note the following:

NOTE:

If there are small impressions on the fins. Refer to COOLER AND CONDENSER ASSEMBLY .

Replace the seal.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

All of the coolant must be changed if the radiator was replaced.

-- Check the coolant level. Refer to COOLANT, DRAINING AND FILLING .

WARNING:

Fire hazards and risk of damage for a faulty engine cover.

  • The engine cover must be always be installed before the hood is closed.
  • The engine may neither be started nor driven without an engine cover.
scientia non olet · About LEMON Manuals