Measurement Preparations

Special tools and workshop equipment required 

• Brake Pedal Actuator:VAG1869/2  .
• Steering Wheel Scales:VAS6458 
• Wheel Alignment Computer released by VW/Audi

• The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
• Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
• Drive the vehicle onto the alignment rack without tension. Move the vehicle back and forth if necessary to relieve any tension on the axle components.
• The steering wheel must be "evened out" into the center position before beginning the measuring and adjusting. Use :VAS6458  for this.