Part II

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

For Valvetrain, Engine With One Camshaft Adjusters - Part I. Refer to Part I .

Fig 1: Exploded View Of Valvetrain (Engine With One Camshaft Adjusters - Part II)

Courtesy of AUDI OF AMERICA, LLC

Cylinder Head
Ball Pin
- For the engine cover
- 9 Nm
O-ring
- Always replace after removing
- Coat with engine oil
Plugs
Oil Separator
- Removing and installing. Refer to OIL SEPARATOR, REMOVING AND INSTALLING .
Bolt
- Tightening specification and sequence. Refer to Fig 2.
Seal
- Always replace after removing
Vacuum Pump
- Overview. Refer to VACUUM SYSTEM .
Bolt
- Tightening specification. Refer to VACUUM SYSTEM .
Seal
- Always replace if damaged
O-ring
- Always replace after removing
- Coat with engine oil
Camshaft Position Sensor -G40-
- Overview. Refer to OVERVIEW - IGNITION SYSTEM .
Bolt
- Tightening specification -13- OVERVIEW - IGNITION SYSTEM => List Item:Bolt
Bolts
- 9 Nm
Bracket
- For EVAP Canister Purge Regulator Valve 1 -N80-

Fig 2: Oil Seperator Bolts Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC