Vibration Damper Seal, Replacing: Procedure: Removing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the vibration damper. Refer to VIBRATION DAMPER, REMOVING AND INSTALLING .

The : T10531/2 is installed.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the seal -arrow- with the : T40274 .

-- Clean the contact and sealing surface.

-- Push the seal -arrow- on the : T10354 .

Courtesy of AUDI OF AMERICA, LLC

The closed side of the seal points to the : T10354 .

-- Push the seal -arrow- with the : T10354 on the : T10531/2 and place on the lower timing chain cover.

Courtesy of AUDI OF AMERICA, LLC

-- Additionally attach the : T10375 and tighten the : T10531/4 .

Courtesy of AUDI OF AMERICA, LLC

-- Drive the seal in all the way using the : T10354 .