Timing Chain Cover, Removing And Installing, Engine With One Camshaft Adjuster: Installing

WARNING: This page is about a different car, the 2018 Audi Q3 Quattro, 2018 Audi Q3, 2017 Audi Q3 Quattro, and 2017 Audi Q3. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal and note the following:

Replace the gasket and O-ring after removal.

-- Coat the seal and the O-ring with engine oil.

Seal installation position: smaller inner diameter points outward.

-- Install the Camshaft Adjustment Valve 1 -N205-. Refer to Camshaft Adjustment Valve 1 -N205-, REMOVING AND INSTALLING .

Additional procedures depending on the model. Refer to Removing .