Overview - SUBFRAME Mount
- Engine Support
- Bolt
- Always replace
- Tightening sequence. Refer to Fig 2.
- Engine Mount
- With support arm
- Removing and installing. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
- Bolt
- 40 Nm + 90°
- Always replace
- Bolt
- 20 Nm + 90°
- Always replace
- Bolt
- 60 Nm + 90°
- Always replace
- Pendulum Support
- Removing and installing. Refer to PENDULUM SUPPORT, REMOVING AND INSTALLING .
- Bolt
- Always replace
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Always replace
- Tightening specification and sequence. Refer to Fig 3.
- Bolts
- Always replace
- Tightening specification and sequence. Refer to Fig 3.
- Bolt
- Tightening specification. Refer to ASSEMBLY MOUNTS and TRANSMISSION, REMOVING AND INSTALLING .
- Bolt
- Tightening specification. Refer to ASSEMBLY MOUNTS and TRANSMISSION, REMOVING AND INSTALLING .
- Transmission Mount
- With support arm
- Transmission Support
- There are different versions. For the correct allocation. Refer to parts information.
- Bolt
- Tightening specification. Refer to ASSEMBLY MOUNTS and TRANSMISSION, REMOVING AND INSTALLING .
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten the bolts -1 through 3- in three steps in the sequence shown:
-- 1. Tighten the bolts to 7 Nm.
-- 2. Tighten the bolts to 40 Nm.
-- 3. Turn the bolts an additional 180°.
NOTE:
Replace any bolts that were tightened with an additional turn.
-- Tighten the bolts in three steps and in the sequence shown:
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -2 and 3- | 50 Nm |
| 2. | -1- | 100 Nm |
| 3. | -1 to 3- | Tighten an additional 90° |