Overview - Camshaft Timing Chain
- Bolt
- 9 Nm
- Chain Tensioner
- Is under tension
- Remove the Locking Pin :T40011 before removing
- Timing Chain Tensioning Rail
- Guide Pins
- 20 Nm
- Bolt
- 9 Nm
- Control Valve
- 35 Nm
- Left thread
- Depending on the version, remove with either the Central Valve Assembly Tool :T10352 or Central Valve Assembly Tool :T10352/1A
- Bolt
- M6: 8 Nm + 90°
- M8: 20 Nm +90°
- Always replace
- Washer
- Bearing Bracket
- Removing and Installing. Refer to BEARING BRACKET, REMOVING AND INSTALLING .
- Camshaft Timing Chain Glide Rail
- Camshaft Housing
- Camshaft Timing Chain
- Before removing, mark the direction of rotation with paint
- Removing and installing. Refer to CAMSHAFT TIMING CHAIN, REMOVING AND INSTALLING .
- Camshaft Timing Chain Glide Rail
- Guide Pins
- 20 Nm
- Three Stage Chain Sprocket
- Crankshaft
- Installed position. Refer to the illustration below
- Both surfaces must -arrows- must line up across from each other.