Overview - Balance Shaft Drive Chain: Notes
- Guide Pins
- 20 Nm
- Glide Rail
- For the timing chain
- Timing Chain
- Removing. Refer to BALANCE SHAFT DRIVE CHAIN, REMOVING AND INSTALLING .
- Guide Pins
- 20 Nm
- Tensioning Rail
- For balance shaft drive chain
- Balance Shaft
- Exhaust side
- Must be replaced after removing
- Lubricate the bearing with engine oil
- Replacing. Refer to .
- Guide Pins
- 20 Nm
- Glide Rail
- For the timing chain
- Chain Tensioner
- 85 Nm
- Coat the seal with sealant
- Three Stage Chain Sprocket
- Installed position. Refer to 15
- O-Ring
- Lubricate with engine oil
- Mounting Pin
- Lubricate with engine oil
- Installed position. Refer to 15
- Intermediate Sprocket
- The intermediate sprocket must be replaced if the bolt -item 15- OVERVIEW - BALANCE SHAFT DRIVE CHAIN is loosened.
- Washer
- Bolt
- Always replace
- The intermediate sprocket -item 13- OVERVIEW - BALANCE SHAFT DRIVE CHAIN must be replaced if the bolt is loosened.
- Tightening sequence. Refer to the illustration below
- Replace and lubricate the O-ring -1-
- The alignment pin -arrow- for the bearing pins must engage in the hole in the cylinder block.
- Lubricate the bearing pins