Pistons, Removing And Installing: Removing
- Engine is secured to the :VAS6095 .
-- Remove the cylinder head. Refer to CYLINDER HEAD, REMOVING AND INSTALLING .
-- Remove the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
-- Mark the installed position and cylinder allocation.
-- Mark installed position and connecting rod cylinder -item ) OVERVIEW - PISTON AND CONNECTING ROD.
-- Remove the connecting rod bearing cap and pull the piston and connecting rod upward.
NOTE:
Warm The Piston To Approximately 60 °C (140 °F) If It Is Difficult To Move The Piston Pin.
-- Remove the locking ring from the eye of the piston bolt.
-- Remove the piston pin using the :VW222A .